sh int dialer 0
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown

Hardware ile IOS arasında sorun yaşanıyor. Güncel IOS lar için [url]www.cisco.com[/url] adresinden bakabilirsin. Hatalı olabilir ama aklımda kaldığı kadarı ile IOS 12.3(5) T gibi bi version hatırlıyorum ama kesin doğru bilgi değil.


________________________________

Kimden: esat yasar caglayan [mailto:[email protected]]
Gönderilmiş: Per 24.02.2005 11:06
Kime: [email][email protected][/email]
Konu: Re: YNT: [cisco-ttl] 1760 router ADSL konfigürasyonu




oradaki pvc 8/35 onu eksik yazm#305;#351;#305;m kusura bakmay#305;n

eski tip devrede bulu#351;turdum encapsulation tipini aal5mux seçerek


fakat yeni tip devrelerde yeni tip devrelerde henüz bulu#351;turamad#305;m konfigürasyonu tekrar gönderiyorum

!
interface ATM0/0
no ip address
no ip mroute-cache
load-interval 60
no atm ilmi-keepalive
dsl operating-mode auto
pvc 8/35
encapsulation aal5snap
protocol ppp dialer
dialer pool-member 1
!
!
interface FastEthernet0/0
ip address 192.168.2.146 255.255.255.0
speed auto
!
interface Dialer0
ip address negotiated
ip nat outside
encapsulation ppp
load-interval 60
dialer pool 1
no cdp enable
ppp pap sent-username ([email protected]) password (password)


sh int dialer 0
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address will be negotiated using IPCP
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Interface is bound to Vi2
Last input never, output never, output hang never
Last clearing of "show interface" counters 19:24:20
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
1 minute input rate 0 bits/sec, 0 packets/sec
1 minute output rate 0 bits/sec, 0 packets/sec
917 packets input, 57024 bytes
7 packets output, 149 bytes
Bound to:
Virtual-Access2 is up, line protocol is down
Hardware is Virtual Access interface
MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP REQsent
PPPoATM vaccess, cloned from Dialer0
Vaccess status 0x44
Bound to ATM0/0 VCD: 14, VPI: 8, VCI: 35, loopback not set
Keepalive set (10 sec)
Interface is bound to Di0 (Encapsulation PPP)
Last input never, output never, output hang never
Last clearing of "show interface" counters 01:38:26
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
1046 packets output, 12552 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions







Borusan Oto Istinye Help Desk <[email protected]> wrote:

PVC 8/35 olması lazım birde IOS'unun ADSL Kartı destekliyor olması önemli.

________________________________

Kimden: Uragan [mailto:[email protected]]
Gönderilmiş: Per 24.02.2005 09:22
Kime: [email][email protected][/email]
Konu: Re: [cisco-ttl] 1760 router ADSL konfigürasyonu




selam sankı PVC eksik gibi ????

----- Original Message -----
From: "esat yasar caglayan"
To:
Sent: Wednesday, February 23, 2005 10:09 PM
Subject: [cisco-ttl] 1760 router ADSL konfigürasyonu



iyi çalışmalar 1760 Router üzerinde 1 WIC ADSL interface card ile internete
çıkartmaya çalışıyorum ama bir türlü devreyi up olarak göremedim bana bu
konuda yardımcı olabilir misiniz ?

konfigürasyon aşağıdadır

interface atm 0/0
no ip address
no ip directed broadcast
no ip mroute-cache
pvc /35
encapsulation aal5snap
protocol ppp dialer
dial pool-member 1
!
interface dialer 0
no ip dirtected-broadcast
encapsulation ppp
dialer pool 1
ppp pap sent-username ([email protected]) password (password)

sh int atm 0/0 dediğim zaman serial is up line protocol is up gözüküyor

sh int dialer 0 dediğimde de
virtual template kısmında serial is up line protocol down diyor

yardımlarınız için teşekkürler