Merhaba,
Sahip olduğumuz 2960X modelindeki swicth üzerindeki 51 ve 52 nolu portlar bir türlü up olmuyor. FC müdüllerde problem yok. Çünkü diğer 2960X üzerinde çalışıyor. Fiber pacht kabloda problem yok. Single mode fiberde problem yok. Onlarda diğer cihazda denendi. Bir switch te 2 portun arızalı olama ihtimali nedir. Gözdem kaçırdığım bir durum var.
shutdown ve no shutdown komutlarıda işe yaramıyor.
İyi çalışmalar.
GigabitEthernet2/0/51 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is bcf1.f226.a2b3 (bia bcf1.f226.a2b3)
MTU 1500 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex, Auto-speed, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 10 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Bu Konuyu Paylaşın !