Bir routerda vpdn konfigurasyonu yapılması için IP plus bir IOS'e sahip olması lazım (c1005-is-mz....)
Cisco'nun sayfasında hangi ios versiyonlarının vpdn desteklediğini görebilirsiniz.

-----Original Message-----
From: Ali KAPTAN [mailto:[email protected]]
Sent: Wednesday, March 31, 2004 8:00 PM
To: [email][email protected][/email]
Subject: [cisco-ttl] cisco 1005 router üzerinde vpdn enable olmuyor. neden olabilir?



# sh ver
Cisco Internetwork Operating System Software
IOS (tm) 1005 Software (C1005-Y-M), Version 12.0(3), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 08-Feb-99 17:46 by phanguye
Image text-base: 0x02004000, data-base: 0x0236FA7C

ROM: System Bootstrap, Version 5.3.2(9) [vatran 9], RELEASE SOFTWARE (fc1)
BOOTFLASH: 1000 Bootstrap Software (C1000-RBOOT-R), Version 10.3(9), RELEASE SOFTWARE (fc1)

Abali_Yem uptime is 5 hours, 11 minutes
System restarted by power-on
System image file is "flash:c1005-y-mz_120-3.bin"

cisco 1000 (68360) processor (revision @) with 7680K/512K bytes of memory.
Processor board ID 14438358
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
8K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read/Write)

Configuration register is 0x2102

#conf t
Enter configuration commands, one per line. End with CNTL/Z.