Cisco 1005 Router üzerinde VPDN Enable Olmuyor. Neden Olabilir?
CLI Guru - Cisco Eğitim ve Danışmanlık Merkezi |

+ Konuyu Cevapla
Toplam 2 sonuçtan 1 ile 2 arasındakiler gösteriliyor.
Cisco 1005 Router üzerinde VPDN Enable Olmuyor. Neden Olabilir?

sh ip int ciktisini gonderir misiniz? Ozgur Ozdemircili [url]http://www.enderunix.org[/url] <http://www.enderunix.org/> [url]http://haber.enderunix.org[/url] <http://haber.enderunix.org/> -----Original Message----- From: Ali KAPTAN [mailto:[email protected]] Sent: Wednesday, March 31, 2004 8:00 PM To: [email][email protected][/email] Subject: [cisco-ttl] cisco

  1. #1
    Ozdemircili Ozgur Civ 425 ABS/SGST Guest

    Standart Cisco 1005 Router üzerinde VPDN Enable Olmuyor. Neden Olabilir?

    sh ip int ciktisini gonderir misiniz?


    Ozgur Ozdemircili

    [url]http://www.enderunix.org[/url] <http://www.enderunix.org/>
    [url]http://haber.enderunix.org[/url] <http://haber.enderunix.org/>

    -----Original Message-----
    From: Ali KAPTAN [mailto:[email protected]]
    Sent: Wednesday, March 31, 2004 8:00 PM
    To: [email][email protected][/email]
    Subject: [cisco-ttl] cisco 1005 router üzerinde vpdn enable olmuyor. neden
    olabilir?




    # sh ver
    Cisco Internetwork Operating System Software
    IOS (tm) 1005 Software (C1005-Y-M), Version 12.0(3), RELEASE SOFTWARE (fc1)
    Copyright (c) 1986-1999 by cisco Systems, Inc.
    Compiled Mon 08-Feb-99 17:46 by phanguye
    Image text-base: 0x02004000, data-base: 0x0236FA7C

    ROM: System Bootstrap, Version 5.3.2(9) [vatran 9], RELEASE SOFTWARE (fc1)
    BOOTFLASH: 1000 Bootstrap Software (C1000-RBOOT-R), Version 10.3(9), RELEASE
    SOFTWARE (fc1)

    Abali_Yem uptime is 5 hours, 11 minutes
    System restarted by power-on
    System image file is "flash:c1005-y-mz_120-3.bin"

    cisco 1000 (68360) processor (revision @) with 7680K/512K bytes of memory.
    Processor board ID 14438358
    Bridging software.
    X.25 software, Version 3.0.0.
    1 Ethernet/IEEE 802.3 interface(s)
    1 Serial network interface(s)
    8K bytes of non-volatile configuration memory.
    4096K bytes of processor board PCMCIA flash (Read/Write)

    Configuration register is 0x2102

    #conf t
    Enter configuration commands, one per line. End with CNTL/Z.

  2. #2
    Ali KAPTAN Guest

    Standart RE: [cisco-ttl] cisco 1005 router üzerinde vpdn enable olmuyor. neden olabilir?

    #sh ip int
    Ethernet0 is up, line protocol is up
    Internet address is 212.98.204.113/28
    Broadcast address is 255.255.255.255
    Address determined by non-volatile memory
    MTU is 1500 bytes
    Helper address is not set
    Directed broadcast forwarding is disabled
    Outgoing access list is not set
    Inbound access list is not set
    Proxy ARP is enabled
    Security level is default
    Split horizon is enabled
    ICMP redirects are always sent
    ICMP unreachables are always sent
    ICMP mask replies are never sent
    IP fast switching is enabled
    IP fast switching on the same interface is disabled
    IP Fast switching turbo vector
    IP multicast fast switching is disabled
    IP multicast distributed fast switching is disabled
    Router Discovery is disabled
    IP output packet accounting is disabled
    IP access violation accounting is disabled
    TCP/IP header compression is disabled
    RTP/IP header compression is disabled
    Probe proxy name replies are disabled
    Policy routing is disabled
    Network address translation is disabled
    Web Cache Redirect is disabled
    BGP Policy Mapping is disabled
    Serial0 is up, line protocol is up
    Internet address is 212.15.0.238/30
    Broadcast address is 255.255.255.255
    Address determined by non-volatile memory
    MTU is 1500 bytes
    Helper address is not set
    Directed broadcast forwarding is disabled
    Outgoing access list is not set
    Inbound access list is not set
    Proxy ARP is enabled
    Security level is default
    Split horizon is enabled
    ICMP redirects are always sent
    ICMP unreachables are always sent
    ICMP mask replies are never sent
    IP fast switching is enabled
    IP fast switching on the same interface is enabled
    IP Fast switching turbo vector
    IP multicast fast switching is disabled
    IP multicast distributed fast switching is disabled
    Router Discovery is disabled
    IP output packet accounting is disabled
    IP access violation accounting is disabled
    TCP/IP header compression is disabled
    RTP/IP header compression is disabled
    Probe proxy name replies are disabled
    Policy routing is disabled
    Network address translation is disabled
    Web Cache Redirect is disabled
    BGP Policy Mapping is disabled
    #

    _____

    From: Ozdemircili Ozgur Civ 425 ABS/SGST
    [mailto:[email protected]]
    Sent: Thursday, April 01, 2004 8:16 AM
    To: '[email protected]'
    Subject: RE: [cisco-ttl] cisco 1005 router üzerinde vpdn enable olmuyor.
    neden olabilir?


    sh ip int ciktisini gonderir misiniz?


    Ozgur Ozdemircili

    [url]http://www.enderunix.org[/url] <http://www.enderunix.org/>
    [url]http://haber.enderunix.org[/url] <http://haber.enderunix.org/>

    -----Original Message-----
    From: Ali KAPTAN [mailto:[email protected]]
    Sent: Wednesday, March 31, 2004 8:00 PM
    To: [email][email protected][/email]
    Subject: [cisco-ttl] cisco 1005 router üzerinde vpdn enable olmuyor. neden
    olabilir?




    # sh ver
    Cisco Internetwork Operating System Software
    IOS (tm) 1005 Software (C1005-Y-M), Version 12.0(3), RELEASE SOFTWARE (fc1)
    Copyright (c) 1986-1999 by cisco Systems, Inc.
    Compiled Mon 08-Feb-99 17:46 by phanguye
    Image text-base: 0x02004000, data-base: 0x0236FA7C

    ROM: System Bootstrap, Version 5.3.2(9) [vatran 9], RELEASE SOFTWARE (fc1)
    BOOTFLASH: 1000 Bootstrap Software (C1000-RBOOT-R), Version 10.3(9), RELEASE
    SOFTWARE (fc1)

    Abali_Yem uptime is 5 hours, 11 minutes
    System restarted by power-on
    System image file is "flash:c1005-y-mz_120-3.bin"

    cisco 1000 (68360) processor (revision @) with 7680K/512K bytes of memory.
    Processor board ID 14438358
    Bridging software.
    X.25 software, Version 3.0.0.
    1 Ethernet/IEEE 802.3 interface(s)
    1 Serial network interface(s)
    8K bytes of non-volatile configuration memory.
    4096K bytes of processor board PCMCIA flash (Read/Write)

    Configuration register is 0x2102

    #conf t
    Enter configuration commands, one per line. End with CNTL/Z.

+ Konuyu Cevapla

Bu Konuyu Paylaşın !

Bu Konuyu Paylaşın !

Yetkileriniz

  • Konu Acma Yetkiniz Yok
  • Cevap Yazma Yetkiniz Yok
  • Eklenti Yükleme Yetkiniz Yok
  • Mesajınızı Değiştirme Yetkiniz Yok